Other Terminals; Connecting External Speakers - Sharp PN-655RE Mode D'emploi

Other terminals

Audio output terminals
• Audio sounds which are input through the audio input terminal or PC audio input terminal are output.
Connect to the audio input terminals of the connected equipment using an audio (RCA) cable
(commercially available).
• The audio output varies depending on the input mode selection (see page 20).
• The volume level can be adjusted using the volume adjustment (see page 20).
PC digital RGB (DVI-D) output terminal
The video from the PC digital RGB (DVI-D) input terminal can be output to external equipment. Use this terminal
to connect multiple units in a daisy chain using digital signal (DVI) cables (commercially available). Refer to page
15 for a connection example.
RS-232C input/output terminals
You can control the monitor from a PC by connecting an RS-232C straight cable (commercially available)
between this terminal and the PC. (See pages 33 and 34.)

Connecting External Speakers

Be sure to use external speakers with an impedance of 6 ohms and a rated input of at least 10 W.
1. While pushing the tab, insert the tip of the cable.
2. Release the tab.
1.
Caution
• Be sure to connect the + and - terminals and the left and right speakers properly.
• Avoid short circuiting the + and - terminals.
2.
Connecting Peripheral Equipment
13
E