Dimensional Drawings - Sharp PN-655RE Mode D'emploi

Dimensional Drawings

Note that the values shown are approximate values. Unit: mm
871
Screw holes for mounting brackets
Opening width
(807)
40 40
923
6 150
440
1003
When mounting the monitor, read the manual of the brackets or stand for their mounting procedure.
The screw holes for mounting brackets (M10 x 4 holes) are provided on the rear of the monitor. Note
that screw hole depth of the monitor is 30 mm. Loose holding may cause the product to fall, resulting in
serious personal injuries as well as damage to the product. The screw and hole should come together
with over 20 mm length of thread. SHARP recommends using mounting interface that comply with
UL1678 standard.
52
E