Switching The Screen Size - Sharp PN-655RE Mode D'emploi

Switching the screen size

Switching the screen size (When the input mode is DIGITAL/ANALOG)
Even when the screen size is changed, the display may remain the same depending on the input signal.
WIDE
Displays image so it fills the
entire screen.
NORMAL
Displays image so it fills the
screen without changing the
aspect ratio of the input
signals.
MODE (Screen mode selection)
Each time you press this button, the screen mode changes in the following
order:
• STD (Standard) → OFFICE *1 → VIVID → sRGB *2 → STD...
*1 Display brightness is lowered. (This mode saves power.)
*2 When the input mode is DIGITAL/ANALOG.
sRGB is international standard of colour representation specifi ed by IEC
(International Electrotechnical Commission).
Colour conversion is made in taking account of liquid crytal's characteristics and
represents colour tone close to its original image.
DISPLAY
Displays monitor information. The display disappears when this button is
pressed again or disappears automatically after approximately 15 seconds.
INFORMATION
INPUT MODE :
SIZE :
MODE :
BRIGHT :
VOLUME :
OFF TIMER :
ID No. :
MODEL :
S/N :
1 9 2 0 x 1 0 8 0
V: 60 Hz
ZOOM 1
An image with a 4:3 aspect ratio is
enlarged to fill the entire screen
without changing the aspect ratio. The
edges of the image may be cut off.
DotbyDot
Displays the dots of the signals
input from the connected PC as
the corresponding dots on the
screen. *
Basic Operation
ANALOG
ANALOG
WIDE
OFFICE
23
15
10:38
18
PN-655RE
XXXXXXXXX
H: 66.3 kHz
ZOOM 2
Use this size if ZOOM 1 cuts
off the subtitles.
* With a monitor with a screen
resolution of 1600 x 1200,
selecting DotbyDot displays the
NORMAL screen.
21
E