2 SAFETY PRECUATIONS
2.1
INSTRUCTIONS FOR THE INSTALLER
• Make sure that the place of installation of the stove
meets all local, national and European rules and
regulations.
• Comply with the indications given in this manual.
• Check that the flue and air intake are suitable for the
type of installation opted for and all local, national and
European rules and regulations.
• The electrical connection must not be done using
temporary or non-insulated leads.
• Check that the earthing of the electrical system is efficient.
• Always use the individual safety devices and the other
protection gear as established by law.
2.2
INSTRUCTIONS FOR THE USER
• Prepare the place of installation of the stove in accordance
with the local, national and European rules and regulations.
• Do not use the stove if the power supply is cut off or
if the circulator or control unit of the hydraulic system
are faulty.
• In case of power outage or malfunction of the electric
and electronic components while the stove is running,
do not load any more wood until the stove cools down
completely.
•
Since the stove is an appliance that heats, its outer
surfaces can get very hot.
• For this reason we advise maximum caution when it is
working, in particular:
A) Do not touch or go near the glass door as you
could get burnt;
B) do not touch the smoke discharge;
C) do not empty the ashes;
D) do not do any type of cleaning;
E) make sure that children are kept away.
• Comply with the indications given in this manual.
• Only use fuel that complies with the indications given
in the chapter referring to fuel characteristics.
• Keep strictly to the maintenance programme to the
stove and to the system.
• Do not use the stove without first having carried out
the daily inspection as specified in the "Maintenance and
Cleaning" chapter in this manual.
• Do not use the stove if there is a malfunction, a
suspected breakage or noises.
• Do not throw water on the stove when it is lit or to put
the fire out in the hearth.
• Do not lean against the open door during the cleaning
operations.
• Do not use the stove as a support or anchor of any
type.
• Do not clean the stove until the structure and ashes
are completely cold.
• All work must be carried out in maximum safety and
calmly.
• In the event of a chimney fire, attempt to extinguish
the fire by closing the primary air required for combustion.
004778530 - 11/09/2020
Immediately call for emergency assistance.
• The safety and filling pipes must be protected against
freezing wherever this may occur.
• Do not use the stove as an incinerator for waste. Use
only recommended fuel.
• If the stove malfunctions due to improper draught of
the flue, clean it contacting qualified personnel.
• The flue system must be cleaned after every 4 tonnes
of wood burnt, or at least once a year, unless otherwise
required by regulations.
Imperfect draft of the flue may also be caused by
especially severe weather conditions (typically low
pressure). In this case the flue must be well heated.
2.3
PRECAUTIONS FOR THE MAINTENANCE
ENGINEER
Comply with the indications given in this manual.
• Always use individual safety devices and other
protection means.
• Before undertaking any maintenance, if the stove has
been used, it must be completely cold.
Even if only one of the safety devices is not working, the
stove is to be considered "not working".
17