Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Installation
• Ceiling diffuser fixing
Cut a 200 mm diameter hole in the ceiling in the chosen installation position. Use the template provided if
necessary.
1) Mark a circle on the ceiling and cut out the hole using the most suitable tool for each type of ceiling.
1
2) Mark the holes on the ceiling with a pencil and fix the diffuser group by means of the wall plugs, screws and
washers supplied.
2
3) It is possible to apply one or two blanking plates to the diffuser in order to to divert the passage of air in one
or two directions to guide airflow away from the smoke detector. According to the installation needs, six
different configurations are available.
The application of the blanking plates allows to have less than 1 m distance between the side of the diffuser
where the blanking plates are installed and a smoke detector. On the sides without the blanking plates the
distance between the smoke detector and the diffuser must be equal to or greater than 1.5 m.
Note: No more than 2 blanking plates to be used on a diffuser.
3
1
2
3
A
4
5
6
7
Publicité
