Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Home screen: switching on the appliance
Display parameters
Home screen: ACTUAL SPEED, T°C, HEATER STATE
FILTER CHANGE IN
OPERATION TIME - Data Logger
HEATER ON TIME
TIME
On this screen it is displayed:
On the first line:
- Speed selected (normal or boost) and corresponding airflow (l/s). Refer to
"Set speed" under the "Configuration Menu" for setting the desired speed
value.
- actual temperature in the loft.
- 'FAN STOPPED' signal when the unit will switch to "Standby Mode" (refer
to "Automatic functioning" under "Operation" section to check the
conditions when the unit will switch to "Standby Mode")
On the second line: the Heater State [NO Heater, Heater OFF, Heater AUTO
(OFF), Heater AUTO (ON)]. See "Heater" section under "Edit parameters"
menu.
Press the down arrow once to display filter information.
This screen displays the remaining time before filter replacement, expressed
in Years/Months/Days/Hours. Refer to the "Maintenance" section for the
recommended filter replacement interval. The timer resets automatically
when the filter is replaced.
Press the down arrow once to dispaly 'operation time'.
This screen displays the total operating time of the appliance from the first
installation, expressed in Years / Months / Days / Hours.
Press the down arrow once to display 'heater on time'.
This screen displays the total operating time of the heater since the first
installation, expressed in Years/Months/Days /Hours.
Press the down arrow once to display the current time.
Press the down arrow once will return you to the speed / heater screen.
The up arrow can be used to cycle back through the screens.
21
Publicité
