Publicité
16
Instructions for Use
Use
The green LED located on the TV 801 Navigator base front panel
indicates with its flashing frequency the system operating conditions:
TV 801 Navigator Switching off
To switch off the TV 801 Navigator it is necessary to remove the
mains. The integrated controller immediately stops the pump.
WARNING!
The Turbo-V controller must be powered with 3-wire power cord (see
orderable parts table) and plug (internationally approved) for user's safety.
Use this power cord and plug in conjunction with a properly grounded power
socket to avoid electrical shock and to satisfy CE requirements. High voltage
developed in the controller can cause severe injury or death. Before
servicing the unit, disconnect the input power cable..
Emergency Stop
To immediately stop the TV 801 Navigator in an emergency condition
it is necessary to remove the supply cable from the mains plug.
204/252
with no flashing: the pump is normally rotating;
slowly flashing (period of about 400 ms): the system is in ramp,
or in braking, or in Stop, or in "Waiting for interlock" status;
fast flashing (period of about 200 ms): error condition.
TV 801 Navigator User Manual / 87-900-953-01
(G)
Publicité
