Peg-Perego VIAGGIO 2-3 SHUTTLE Notice D'emploi page 22

• Never remove your child from the seat
when the vehicle is moving.
• Check that the car seat is not blocked
by a moving part of the seat or a door.
• Adjust the height and tension of the
belts, checking that they adhere to the
child's body without being too tight.
Check that the seat belt is not twisted
and the child cannot unfasten it.
• Do not use the car seat without
the lining. This lining cannot be
replaced by other lining that has not
been specifically approved by the
manufacturer because it is an integral
part of the seat and is essential for
safety purposes.
• Do not remove or replace the white
part in polystyrene under the seat, as it
is essential for safety purposes.
• If in doubt, contact the manufacturer
or retailer of this car seat.
• This article is progressively numbered
through its certification label, located
on the bottom of the seat (fig. 24).
• Do not remove the adhesive and sewn
labels. Removal of these labels could
result in the product not complying
with the law.
• Do not alter the product.
• Contact the post-sales service for
repairs, the replacement of components
and information on the product;
contact information is provided on the
last page of this manual.
• When not in use, the car seat can be
left in the vehicle provided it is attached
to the vehicle's Isofix attachments;
otherwise, remove it from the vehicle:
in the event of an accident it could be
dangerous for other passengers.
• Do not use accessories that have not
been approved by the manufacturer or
competent authorities.
• Never put hot drinks in cup holders
(if any).
• Do not remove or replace the white
polystyrene part under the seat, in the
backrest and in the headrest, as it is
essential for safety purposes.
• Do not use the child car seat if it is
broken or if there are missing parts,
or if it has been subjected to heavy
impacts as a result of accidents, as it
may have suffered structural damage
which is not visible but is extremely
hazardous.
• If using a second-hand product,
make sure it is a recent model,
comes with instructions, and is fully
functional in all parts. An obsolete
product may not conform to safety
standards, due to natural ageing of
materials and updating of regulations.
If you have any doubts, contact the
manufacturer's
centre.
1_ IMPORTANT
• "Viaggio 2-3 Shuttle": this car seat,
Group 2-3, must be installed in the
direction of travel.
• Do not install "Viaggio 2-3 Shuttle"
on seats that are not in the direction
of travel or are transversal to the
direction of travel.
• It is always advisable to fit the car
seat on the rear vehicle seat and on
the passenger's side.
22
customer service