Dolmar MS248.4C Instructions D'emploi D'origine page 23

Replacing the nylon cord
(For ultra auto 4)
First, stop the engine.
Cover
Press on the housing latches inward to lift off the cover, then remove the spool.
Latches
Press
Press
Hook the center of new nylon cord into the notch in the center of the spool, with
Spool
80 mm (3-1/8")
one end of the cord extending about 80 mm (3-1/8") more than the other.
Then wind both ends firmly around the spool in the direction of the head rotation
(left-hand direction indicated by LH and right-hand direction by RH on the side
of the spool).
For left hand rotation
Spool
Wind all but about 100 mm (3-15/16") of the cords, leaving the ends temporarily
hooked through a notch on the side of the spool.
100 mm (3-15/16")
Notches
Mount the spool in the housing so that the grooves and protrusions on the
spool match up with those in the housing. Keep the side with letters on the
spool visible on the top. Now, unhook the ends of the cord from their temporary
position and feed the cords through the eyelets to come out of the housing.
Eyelets
Align the protrusion on the underside of the cover with the slots of the eyelets.
Then push cover firmly onto the housing to secure it.
Cover
Protrusion
Slot of eyelet
23