StarLab ErgoOne E Mode D'emploi page 33

10.4 Charge and replace rechargeable battery
A fully charged rechargeable battery allows approx. 8 h of continuous pipetting (over 4000
pipetting cycles) of samples of water-like viscosity and density.
NOTICE!
› Before charging, ensure that the power adapter is suitable for the voltage present in the
laboratory.
› The instrument must not be charged in an explosive environment.
› The rechargeable battery can be charged only inside the ErgoOne® E Multi-Channel pipettes.
Recharge rechargeable battery
a.
Pipetting during the charging process?
During charging, you can continue to work with the ErgoOne® E Multi-Channel pipettes. When the
rechargeable battery is fully discharged, it takes a few minutes to reach a certain minimum charge
capacity. This is necessary for safe operation of the instrument. The last settings made are stored
in the EEPROM of the instrument. In the case of complete discharge or when changing the battery,
these settings remain saved!
Replace rechargeable battery
a.
b.
c.
a. Insert the charging cable plug of the power adapter
into the socket provided for this purpose at the top
of the .
The charging process starts automatically.

During the charging process, the bars of the

rechargeable battery capacity indicator continually
run from the bottom to the top.
Once the bars of the display have stopped, this

means that the rechargeable battery is fully
charged.
a.
Open the cover of the battery compartment,
remove the rechargeable battery, and pull the plug
out of the socket.
b.
Insert the plug of the new rechargeable battery
into the socket and insert the new rechargeable
battery.
c. Replace the cover of the battery compartment
and close it.
Remove the rechargeable battery from the instrument
during longer breaks in operation.
ErgoOne E Multi-Channel Pipettes · User Manual · 33
®