Important Installation Information
This appliance has been tested
in accordance with ANSI Z21.1
current issue, Standard for
Household Cooking Appliances
(USA) and in accordance with
CAN 1.1-M81 Domestic Gas
Ranges (Canadian).
It is strongly recommended that
this appliance be installed in con-
junction with a suitable over-
head vent hood. (See Step 1 for
Ventilation Requirements.) Due
to the high heat capability of this
CAUTION
To eliminate risk of burns or
fire caused by reaching over
heated surface units, cabi-
net storage located above
the surface units should be
avoided.
All manuals and user guides at all-guides.com
unit, particular attention should
be paid to the hood and duct
work installation to assure it
meets local building codes.
Check local building codes for
the proper method of appliance
installation. Local codes vary. In-
stallation, electrical connections
and grounding must comply with
all applicable codes. In the ab-
sence of local codes the appli-
ance should be installed in ac-
CAUTION
(1) When connecting the unit
to propane gas, make cer-
tain the propane gas tank is
equipped with its own high-
pressure regulator in addi-
tion to the pressure regula-
tor supplied with this unit.
The maximum gas pressure
to this appliance is not to
exceed 14.0 inches water
column from the propane
gas tank regulator.
(2) This unit is designed as a
cooking appliance. Based
on safety considerations,
never use it for warming or
heating a room.
2
cordance with the National Fuel
Gas Code ANSI Z223.1 current
issue and National Gas Code
ANSI/NFPA 70 – current issue.
In Canada, installation must be
in accordance with the CAN 1-
B149.1 and .2 – Installation
Codes for Gas Burning Appli-
ances and/or local codes.
This appliance is equipped with
an intermittent/interrupted igni-
tion device that cycles the two
far left surface burners on and off
when in the ExtraLow
®
setting.