SPARKY BR 9,6E Mode D'emploi page 6

▪ To reduce the risk of an electric shock, unplug
the charger from the power supply before at-
tempting to clean it. Removing the battery alone
does not reduce the risk.
▪ Never attempt to connect two chargers togeth-
er.
▪ Do not store or use the tool and battery pack in
locations where the temperature may reach or
exceed 104°F (40°C) such as alongside sheds,
trailers or metal structures during summer.
▪ The charger is designed for use from a stand-
ard household electrical supply (230–240V).
Do not attempt to connect the charger to a sup-
ply with a different supply.
▪ If you wish to charge a second battery pack,
unplug the charger from the mains supply and
leave it for at least 15 minutes. After this time
you can charge a second battery pack.
▪ Under certain conditions, with the charger
plugged in to the power supply, the exposed
charging contacts inside the charger can be
shorted by foreign material. Foreign materials
of a conductive nature such as, but not limited
to, steel wool, aluminium foil, or any build-up
of metallic particles should be kept away from
charger cavities. Always unplug the charger
from the power supply when there is no bat-
tery pack in the cavity. Unplug charger before
attempting to clean.
▪ Do not freeze or immerse charger in water or
any other liquid.
VI - Additional instructions
for work with the
battery pack
▪ The battery pack for this tool has been shipped
in a low charge condition. You should charge
the battery pack fully before use.
CAUtIoN: If the battery pack is cracked
or damaged in any other way, do not insert it
in the charger. There is a danger of electric
shock.
▪ To ensure the longest battery life and best bat-
tery performance, always charge the battery
when the air temperature is between 18–24°C.
Do not charge the battery pack when the tem-
perature is below 0°C, or above 40°C. This is
important. Failure to observe this safety rule
could cause serious damage to the battery
6
EN
pages-BR9,6-12E-15E.indd 6
All manuals and user guides at all-guides.com
▪ The charger and battery pack may become
▪ To prevent overheating, do not charge battery
▪ Do not charge inside a box or container of any
▪ A small leakage of liquid from the battery pack
▪ If the battery pack does not charge properly:
▪ The battery pack should be recharged when it
▪ Do not incinerate the battery pack even if it is
▪ To facilitate the cooling of the battery pack after
battery pack for any reason. If the plastic hous-
ing of the battery pack breaks or cracks, return
to a service centre for recycling.
READ All of tHE INstRUCtIoNs IN tHE CHARGER
sECtIoN of tHIs mANUAl bEfoRE AttEmPtING
to CHARGE tHE bAttERy PACK foR yoUR tool.
pack.
warm to touch while charging. This is a normal
condition, and does not indicate a problem.
packs in direct sunlight in hot weather or near
heat sources.
kind. The battery must be placed in a well venti-
lated area during charging
cells may occur under extreme usage or tem-
perature conditions. This does not indicate a
failure. However, if the outer seal is broken and
this leakage gets on your skin:
Wash quickly with soap and water.
Neutralise with a mild acid such as lemon juice
or vinegar.
If battery liquid gets into your eyes, flush them
with clean water for a minimum of 10 minutes
and seek immediate medical attention.
(medical note: The liquid is 25-35% solution of
potassium hydroxide.)
(1) Check current at receptacle by plugging in a
lamp or other appliance.
(2) Move charger and battery pack to a location
where the surrounding air temperature is ap-
proximately 65°F–75°F (18°C–24°C).
(3) If charging problems persist, take or send
the tool, battery pack and charger to your local
service centre.
fails to produce sufficient power on jobs, which
were easily done previously. DO NOT CON-
TINUE to use under these conditions. Follow
the charging procedure.
seriously damaged or can no longer hold a
charge. The battery pack can explode in a fire.
use, avoid placing the charger or battery pack
in a warm environment such as in a metal shed,
or an uninsulated trailer.
CAUtIoN: Never attempt to open the
bR 9,6E • bR 2E • bR 5E
22.8.2006 г. 14:07:16
▪ Alw
one
exa
pac
ard
▪ Cha
ers.
▪ The
Cad
Use
mun
dam
fIttI
bAtt
To rem
press
the ba
out of
Prior
switch
To ins
with th
tery p
is sitti
ing the
to the
positio
bAtt
charg
after
1. Alig
er u
tion
twe
2. Plu
LED
sup
3. Pre
will
and
4. The
hou
cyc
5. Unp
and