GYS PACK AUTO Mode D'emploi page 15

Translation of the original instructions
NO WARRANTY FOR THE BATTERY
Gyspack contains a high performance battery, which imperatively needs to be recharged after each use. If this condition
is not respected, within 24 hours the battery gets sulphated. This causes an irreversible deterioration of the battery.
For this reason, the battery of the Gyspack, which is expensive, is not under warranty, because its conservation depends
on its use.
BATTERY REPLACEMENT
1
Product Battery
GYSPACK 400 6FM - 18
To replace the battery :
• First the booster must be disconnected form the power supply.
• The back panel must be unscrewed (9 screws) and removed.
• Once the back panel is removed, the battery front appears (cf illustration). The battery is connected to the GYSPACK at two
points : at the - terminal 1 and at the + terminal 2 . To remove the battery, remove the screw that enables the connection
between the battery and the GYSPACK.
When putting a new battery, make sure to observe the polarities of both the battery and the
GYSPACK AUTO/400. Terminal - on the left, terminal + on the right (cf illustration). Put the 2
screws and washers back, tighten the nuts (recommended torque wrench 4 N.m).
• Place the booster's backpanel screws back on.
All manuals and user guides at all-guides.com
GYSPACK AUTO / GYSPACK 400
Type Voltage (V)
Lead- acid battery
Capacity (Ah)
12 18
EN
2
Dimensions
Battery ref
(cm)
33 x 14 x 35 53139
15