GYS PACK AUTO Mode D'emploi page 13

Translation of the original instructions
GENERAL DESCRIPTION
This autonomous starter is intended for the starting of vehicles equipped with a 12 V battery. GYSPACK functions thanks
to a high performance battery. For an appropriate use of the machine and a longer lifetime of its internal battery, it is
essential to connect to the sector the GYSPACK after each use and keep it connected until the next use.
Warning: To avoid any damage or explosion, respect the polarity during the clamp connection.
TESTING OF THE INTERNAL BATTERY
Test the battery before each use: press on the test button, the result is displayed as follow:
- Green indicator: The battery is charged. Can be used for starting vehicles
- Orange indicator: It is strongly advised to recharge the GYSPACK before use.
- Red indicator: obligation to recharge.
Warning: never use the Machine when the red indicator is on.
STARTING OF A VEHICLE
Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information
and a possible inability to restart.
1. Turn ignition off before connecting the GYSPACK to the car's battery.
Do not touch the red clamp with the black clamp.
2. Connect the red clamp to the positive pillar (+) of the battery, then the black clamp to negative pillar (-).
The cables must not be pinched or in contact with hot or sharp surfaces.
3. Go to the driver's seat and turn the ignition key. If your engine does not start, wait 3 minutes until next attempt. ( 6 sec max)
- If the cooling period between each attempt (3 minutes) is not observed or if the duration of the
attempt is too long (> 6 seconds), the chances of a successful jumpstart are significantly reduced
(risk of power loss).
- Risk of battery acid leaks or damage if the recommended periods are not observed.
- If the vehicle does not start, it may be a problem other than a faulty battery: alternator, glowplug...
CHARGING OF THE INTERNAL BATTERY
Connect the main plug to the 220V power supply and the minor plug to the charging socket in the front panel of the
GYSPACK.
The charge stops automatically and the green indicator lights when the battery is charged.
Note: the Gyspack must always be placed in vertical position when in charge. If not, there is a risk of acid leak and
destruction.
All manuals and user guides at all-guides.com
GYSPACK AUTO / GYSPACK 400
EN
13