Conrad renkforce Show Design 2 DMX Notice D'emploi page 56

07. Data load
With this function, you can read backed-up data (see „06 Data backup") back into the DMX controller.
• Plug the USB drive with the saved data into the USB port (3).
• Turn the dial switch PAN (11) until the above menu item appears in the display (12).
• Push the REC/ENTER (4) button.
• LOAD USB FILE will appear in the display (12).
• Use the dial switch PAN (11) to select [YES] and push the REC/ENTER (4) button again.
• PRESS NUMBER KEY SELECT FILE appears in the display (12).
• Use the selection buttons 1-16 (9) to select the serial number of the file that you want to read to start the
process. A progress bar will appear in the display (12).
Reading in must be performed separately for each backup file. When the LED of a memory slot is
lit, this means that there are data for this memory slot on the USB drive.
• When the process has been successfully completed, the display (12) will switch back to the main level.
• Repeat the process described to read in more memory slots.
08. Send fixture Update file
This function is not currently available.
09. Black-out mode
With this menu item you can specify whether all channels or only the dimmer channel are to react to the
BLACK OUT/DEL (6) button.
• Turn the dial switch PAN (11) until the above menu item appears in the display (12).
• Push the REC/ENTER (4) button.
• Use the dial switch PAN (11) to select [ALL CHANNELS] or [ONLY DIMMER] and push the REC/ENTER (4)
button again.
56