Fade Function - Conrad renkforce Show Design 2 DMX Notice D'emploi

• Push the function button CHASE (2).
• Select the desired running light function with the selection buttons 1-16 (9).
To select the memory slots 1-16, level A must be selected with the PAGE (10) button. For memory
slots 17-32, level B must be selected with the PAGE (10) button.
Up to 5 running light functions can be selected at the same time. They are then played in sequen-
ce. The LED of the currently active running light function flashes, the LEDs of the other activated
running light functions are lit.
The display shows the active running light function (CHASE) and the currently active step (STEP)
in the bottom line.
• Push the RUN MODE/SWAP (7) button repeatedly until the desired operating mode is lit in the operating
mode display (MANUAL, MUSIC or AUTO).
MANUAL
The steps are switched on with the dial switch PAN (11).
MUSIC
The steps are switched on in time with the music using an integrated microphone.
The microphone sensitivity can be controlled by keeping the RUN MODE/SWAP (7) button pushed and
adjusting the sensitivity from 0-100% with the dial switch TILT (13).
AUTO
The steps are switched on automatically.
Set the running speed (duration of how long a light scene is displayed (0.1 s to 10 minutes) with the dial
switch PAN (11).
Set the transfer speed (duration between the steps (0-30s)) with the dial switch TILT (13).
If several running light functions have been activated at the same time, only the flashing (current-
ly active) running light function can be set. If you want to set another running light function, keep
its selection button 1-16 (9) pushed and then set the parameters as described above.
• To stop a running light function, push the corresponding selection button 1-16 (9) so that the correspon-
ding LED goes out.
d) FADE Function
The RGBW colour channels and the dimmer channel can be assigned a fade-in or fade-out function for
running light functions.
This function slowly increases or reduces the brightness to a specified value.
• Keep the function button FIXTURE (2) pushed and set the FADE time with the dial switch PAN (11) (setting
range 0-30 seconds).
51