Manual Control; Deleting Running Light Functions; Black-Out Function - Conrad renkforce Show Design 2 DMX Notice D'emploi

e) Manual Control
During playback of a running light function, you can perform manual adjustments with the channel
faders (1) and the dial switches PAN (11) and TILT (13) without having to reprogram light scenes. This is
particularly helpful for smaller selections in the live area.
• Push the function button FIXTURE (2).
• Select the effect light to be adjusted with the selection buttons 1-16 (9).
To select the effect lights 1-16, level A must be selected with the PAGE (10) button. For effect
lights 17-32, level B must be selected with the PAGE (10) button.
• Use the channel faders (1) and the dial switches PAN (11) and TILT (13) to assign the new DMX values.
f) Deleting Running Light Functions
• Keep the REC/ENTER button (4) pushed until the associated LED lights up and the display (12) shows
PROGRAM.
• Push the function button CHASE (2) (associated LED must be lit).
• Keep the BLACK OUT/DEL (6) button pushed and select the running light function to be deleted with the
selection buttons 1-16 (9). All LEDs will flash briefly to display successful deletion.
To select the memory slots 1-16, level A must be selected with the PAGE (10) button. For memory
slots 17-32, level B must be selected with the PAGE (10) button.
• Push the REC/ENTER (4) button until the programming mode is left again.

14. Black-Out Function

This function is used to switch all effect lights completely dark. Running processes are, however, not stop-
ped but continue internally.
• Push the BLACK OUT/DEL button (6) to activate or deactivate the black out function.
• Use the system settings (see next chapter) to specify whether all channels or only the dimmer channel
are to react to the BLACK OUT/DEL (6) button.
52