Calling Light Scenes; Fade Function - Conrad renkforce Show Design 2 DMX Notice D'emploi

• Push the selection buttons 1-16 (9) of the first effect light or the first effect light group involved in the light
scene. The corresponding LEDs must be lit.
To select the effect lights 1-16, level A must be selected with the PAGE (10) button. For effect
lights 17-32, level B must be selected with the PAGE (10) button.
• Assign the desired DMX values for the effect light with the channel faders (1) and dial switches PAN (11)
and TILT (13).
• If you want to assign a movement pattern or colour effect to the effect light, push the function button
MOVEMENT (2) and select the desired movement pattern (buttons 1-9) or the desired colour effect
(buttons 10-16) with the selection buttons 1-16 (9). Then return to the effect light selection with the func-
tion button FIXTURE (2).
• Unselect the first effect light or effect light group again by pushing the corresponding selection button
1-16 (9) again (the corresponding LED must go out).
• Set the DMX values for the other effect lights to be involved in the light scene as described above.
• When the DMX values of all effect lights involved in the light scene are set, push the function button
SCENE (2) and then the REC/ENTER (4) button.
• Select the desired memory slot for the light scenes with the selection buttons 1-16 (9). All LEDs will flash
briefly to display successful storage.
To select the memory slots 1-16, level A must be selected with the PAGE (10) button. For memory
slots 17-32, level B must be selected with the PAGE (10) button.
• Repeat the storage process for further light scenes.
• After all light scenes have been saved, keep the REC/ENTER (4) button pushed until the LED above the
button goes out.
d) Calling Light Scenes
The saved light scenes can be called in manual mode only.
• No effect light must be selected (push FIXTURE (2) button and unselect all effect lights with the selection
buttons 1-16 (9). Please check the two levels A and B.
• Push the function button SCENE (2) and select the desired light scenes with the selection
buttons 1-16 (9). Pushing the button again unselects the light scene again.
Only such light scenes as have been saved before can be called.
To select the memory slots 1-16, level A must be selected with the PAGE (10) button. For memory
slots 17-32, level B must be selected with the PAGE (10) button.
e) FADE Function
The RGBW colour channels and the dimmer channel can be assigned a fade-in or fade-out function for
light scenes.
This function slowly increases or reduces the brightness to a specified value.
• Keep the function button FIXTURE (2) pushed and set the FADE time with the dial switch PAN (11) (setting
range 0-30 seconds).
48