KERN KFS-TM Notice D'utilisation Et D'installation page 87

5 Transport and storage
5.1 Testing upon acceptance
When receiving the appliance, please check packaging immediately, and the appliance
itself when unpacking for possible visible damage.
5.2 Packaging / return transport
 Keep all parts of the original packaging for a possibly required return.
 Only use original packaging for returning.
 Prior to dispatch disconnect all cables and remove loose/mobile parts.
 Reattach possibly supplied transport securing devices.
 Secure all parts such as the wind screen, the weighing plate, power
supply unit etc. against shifting and damage.
6 Unpacking and placing
6.1 Installation Site, Location of Use
The display units are designed in a way that reliable weighing results are achieved in
common conditions of use.
Precise and fast work is achieved by selecting the right place for your display unit
and your weighing plate.
On the installation site observe the following:
• Place the balance on a firm, level surface.
• Avoid extreme heat as well as temperature fluctuation caused by installing next
to a radiator or in the direct sunlight.
• Protect the balance against direct draughts due to open windows and doors.
• Avoid jarring during weighing.
• Protect the balance against high humidity, vapours and dust.
• Do not expose the device to extreme dampness for longer periods of time.
Non-permitted condensation (condensation of air humidity on the appliance)
may occur if a cold appliance is taken to a considerably warmer environment.
In this case, acclimatize the disconnected appliance for ca. 2 hours at room
temperature.
• Avoid static charge of goods to be weighed or weighing container.
• Do not operate in areas with hazard of explosive material or in potentially
explosive atmospheres due to materials such as gasses, steams, mists or
dusts.
• Keep away chemicals (such as liquids or gasses), which could attack and
damage the balance inside or from outside.
• In the event of the occurrence of electromagnetic fields, static charges (e.g.,
when weighing / counting plastic parts) and unstable power supply, large display
deviations (incorrect weighing results, as well as damage to the scale) are
possible. Change location or remove source of interference.
KFS-TM-BA_IA-def-2321 11