LUXMAIN QUICK LIFT L520E Notice Originale page 39

Tolérances générales
ISO 2768-F
Ra (µm)
CHECK POINT AND LUBRICATION
All hinge pins are provided with a small hole for lubrication with SAE 90 type oil (fluid oil). The 6 lubrication points per
boom are shown opposite.
Check that the axle nuts are correctly tightened (the nuts are fitted with a brake to prevent loosening).
TROUBLESHOOTING, CAUSES, SOLUTIONS
Hydraulic Power System Warning: Failure to follow these precautions can result in se-
rious injury and, in rare cases, death.
All connectors must be properly assembled together before using the Quick Lift or ap-
plying pressure.
Never attempt to connect or disconnect the couplers while the equipment is in opera-
tion or if the hydraulic system is under pressure.
Wear protective equipment (goggles, gloves and safety shoes) when handling the
Indice: MPF / Commentaire:
A
Quick Lift.
Matière: (Gys)
If hydraulic fluid comes into contact with the eyes, enters the bloodstream or is swal-
lowed, consult a doctor immediately.
Désignation:
Quick Lift Take every precaution to prevent dust or other debris from entering the hydraulic sys-
tem.
Produit:
Nom du fichier CAO:
The table below shows the anomalies that can be observed when using the QUICK LIFT. If the problem is not listed in
the table below, stop using the tool and immediately contact your dealer or the manufacturer for instructions.
TROUBLESHOOTING
Ramps deploy abnormally or do not des-
cend well. (Trembling)
The ramps are in the maximum position
(unladen, without vehicle) and do not des-
cend.
The ramps do not deploy from their low
position.
QUICK LIFT L520E
Description Jusqu'à 3 Jusqu'à 6
Mécanique ±0.05 ±0.05
Sciage: Ra 25 Fraisage: Ra 3.2
Masse: Traitement: (Code ST Gys)
Surface:
19_03176
Ce document est la propriété de la société GYS et ne peut en aucun cas être transmis à quiconque sans son accord.
Check that there are no hydraulic leaks or that one of the hoses is not
pinched or crushed.
Check that the solenoid valve is active (red knob must be in the down
position).
Check that there is sufficient hydraulic fluid in the tank.
Check that the generating set is working (motor noise).
Bleed the cylinders (procedure p.9).
Contact your dealer or the manufacturer. You need assistance.
The red button on the remote control has been activated.
Turn the button 1/4 turn to deactivate the stop button.
Check that the weight of the vehicle is not > 2500kg.
Check that your vehicle has its wheels.
There must be a minimum space of 2 to 3 cm between the vehicle's
gripping points and the rubber chocks. For a 2500kg vehicle it will
take several centimetres (about ten).
Jusqu'à 30 Jusqu'à 120 Jusqu'à 400
±0.1 ±0.15 ±0.2
Tournage: Ra 1.6 Casser les angles: 0.2 x0.2
Plan de Contôle
Date modification: Modifié par:
23/09/2019
Etabli par: Mickaël TEXIER
Date: 11/03/2019
Statut:
PROTOTYPE
Études
MECANIQUE
CAUSES
Jusqu'à 1000
±0.3
mickael
Format : A4
Echelle: 1:10
Indice: Feuille:
A 1/1
EN
15