Publicité
Les langues disponibles
Les langues disponibles
Problem
The residual heat indicator is not
displaying anything
The automatic warm up function
is not switching itself on
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds when
appliance is switched off
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
Display is switching between
two heat settings
lights up
is lit
and number are displayed
If you are unable to remedy the problem
by following the above suggestions,
please contact your dealer or the Cus-
tomer Care Department.
All manuals and user guides at all-guides.com
Possible cause
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
The cooking zone was only on
for a short time and is therefore
not hot
There is still residual heat on the
cooking zone
The highest heat setting is set
One or more sensor fields have
been covered for longer than 10
seconds
The control panel is wholly or
partly covered by objects.
The On/Off sensor field has
been covered up, e.g. by a cloth
Power management is reducing
the power of this cooking zone
Unsuitable cookware
No cookware on the cooking
zone
The diameter of the bottom of
the cookware is too small for the
cooking zone
Overheating protection for the
cooking zone has been trig-
gered
Automatic switch off has been
triggered
Electronics fault
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on the
control panel. Switch the appli-
ance on again
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
Let the cooking zone cool down
The highest heat setting has the
same power as the automatic
warm up function
Uncover sensor field
Remove objects.
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Place cookware on the cooking
zone
Move onto a smaller cooking
zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few mi-
nutes (Take the fuse out of the
house's wiring system) If after
switching on again,
played again, call the customer
service department
Warning! Repairs to the appliance are
only to be carried out by qualified service
engineers. Considerable danger to the
user may result from improper repairs.
progress 27
Remedy
is dis-
Publicité
