En - Electrical Connection - Miele professional PB7895ms Mode D'emploi

,
All electrical work must be
carried out by a suitably qualified
and competent person in
accordance with current local and
national safety regulations (BS 7671
in the UK).
^ Ensure power is not supplied to this
appliance until after it has been
installed.
^ Connection should be made via a
suitable switched socket which is
easily accessible for servicing and
maintenance work after the appliance
has been installed. An electrical
safety test must be carried out after
installation and after any servicing
work. When switched off there must
be an all-pole contact gap of at least
3 mm in the mains connection switch.
^ The mains connection cable may
only be replaced by an original Miele
spare part or an apppropriate cable
with wire end ferrules.
^ For technical data, see data plate.
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate.

en - Electrical connection

Non-rewireable plugs BS 1363
The fuse cover must be refitted when
changing the fuse, and if the fuse cover
is lost, the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is
embossed in words on the base of the
plug (as applicable to the design of
plug fitted).
Replacement fuses should be ASTA
approved to BS 1362 and have the
correct rating. Replacement fuses and
fuse covers may be purchased from
your local electrical supplier.
WARNING: THIS APPLIANCE MUST
BE EARTHED
33