En - Connecting To The Aqua Purificator - Miele professional PB7895ms Mode D'emploi

en - Connecting to the Aqua Purificator

^ Connect the green hose marked
"H O pur" to the AD water solenoid
2
valve or to the AD inlet connection
hose on the machine.
^ Connect the blue "Inlet" hose to the
on-site cold water stopcock.
See enclosed installation
instructions for further details.
Important
The water pressure (flow rate) must
be between 250 and 1000 kPa
(2.5 -1 10 bar).
The water temperature must not
exceed 20 °C.
^ The plug must be correctly inserted
in the socket and switched on for the
conductivity display to work.
30
Vent the canister
^ Open the vent (see arrow) by turning
it anti-clockwise.
^ Open the cold water stopcock slowly
until water starts to come out of the
vent.
^ Then close the vent.
Install the canister
^ Fit the connected canister in position
at the back of the Aqua Purificator.
The area at the front can be used to
store a spare canister.
^ The Aqua Purificator is ready for use
once the shut-off valve is open.