HumanTechnik lisa Mode D'emploi page 9

Congratulations on purchasing your
RF table flash lamp . We hope it will
give you many years of reassuring
operation. You have purchased a
modern and reliable system.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system's features
to you.
Standard components
Please check if all following compo-
nents are included:
- lisa RF table flash lamp
- 230 V power supply unit
- Operating instructions
- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Functional principle
The RF table flash lamp receives the
radio signals from various radio
transmitters and converts them into
light signals. It possesses a powerful
flash tube which alerts you to a
signal as well as LEDs which indicate
the type of signals which are being
received. In addition, it is possible to
connect a vibrating pad and modules
(accessories).
Setting up the system –
Setting the correct radio channel
A special digital transmission pro-
cess ensures that the radio signals
are picked up without errors. This
process also makes it possible to set
10 different radio channels.
When supplied from the factory, all
RF table flash lamps are set to chan-
nel 0. It is only necessary to set units
to other channels if you have several
different users operating units in the
same building.
Set the channel you want by adjus -
ting the channel selector switch on
the backside of the unit to the requi-
red channel number. Use a small
screw driver to adjust this switch.
All transmitters and receivers must
be set to the same channel.
English 9