IKA C-MAG HS 7 control Mode D'emploi page 45

All manuals and user guides at all-guides.com
The following table summarises the (NAMUR) commands
understood by the IKA equipment.
NAMUR Commands
IN_NAME
IN_PV_1
IN_PV_2
IN_PV_4
IN_PV_5
IN_SP_1
IN_SP_3
IN_SP_4
OUT_SP_1
OUT_SP_1 100
OUT_SP_4
OUT_SP_4 10
START_1
STOP_1
START_4
STOP_4
RESET
SET_MODE_n
(n=A, B or D)
Function
Read the device name
Read actual external sensor value
Read actual hotplate sensor value
Read stirring speed value
Read viscosity trend value
Read rated temperature value
Read rate set safety temperature value
Read rate speed value
Adjust the set temperature value
Set temperature value
Adjust the set speed value
Set speed value
Start the heater
Stop the heater
Start the motor
Stop the motor
Switch to normal operating mode
Set operating mode
Interfaces and outputs 45