IKA C-MAG HS 7 control Mode D'emploi page 22

All manuals and user guides at all-guides.com
Start-up
/// Operation
Remove the protective film from the plate before using device!
Power-up
Press the power button (A) to the right.
1.
Insert the power cord into the power outlet (J).
2.
Press the power button (A) to the left.
3.
› Standard mode A is selected.
Stirring
Set the speed using the rotating knob (D).
1.
› The set speed value (01) is shown on the display (H).
Press the rotating knob (D) to start the stirring function.
2.
Heating
Set the safety temperature limit (11).
1.
Set the target temperature using the rotating knob (C).
2.
› The set temperature value (02) is shown on the display (H).
Set the temperature control mode (09).
3.
Press the rotating knob (C) to start the heating function.
4.
General heating information
› The target and current temperature (02, 07)
are shown permanently on the display (H).
› When the heating function is switched on,
the heater activated symbol (06) is displayed.
› When the device is switched off while the heating plate temperature
is higher than + 50 °C, the display (H) shows HOT! and the current
temperature (07) is shown, even if the device is switched off.
22 Start-up