Publicité
Les langues disponibles
Les langues disponibles
Installation
Instructions
ISTEP 31 INSTALL INSERT SLEEVE
00000
1. Tuck the house wiring out of the way.
2. Install the insert sleeve into the cutout opening of
custom cabinet frame.
÷
Clip-_
........
4. Align 8" duct to exhaust opening of insert sleeve
and seal with aluminum
tape.
NOTE: House duct should drop to 11-1/2" above
bottom edge of insert sleeve or the bottom of the
3/4" cabinet base.
3. Push the insert sleeve straight up through the
cutout opening until the temporary
locking clips
engage. The locking clips are designed to hold the
insert sleeve in place until it is secured with screws.
NOTE: The locking clips are not designed to support
all of the weight of the insert sleeve. Do not leave
the insert sleeve unattended
until screws have been
inserted.
5. Tape the a washers in place over the outside
of the a front and back holes of the insert sleeve.
The washers are designed to be located between
the insert sleeve and the I/a< cabinet surface.
6. Press the sleeve up firmly and secure with the
8 screws provided. The insert sleeve should be
flush with the liner and have no visible gaps.
NOTE: It is IMPORTANT to install front mounting
screw. The front screw hole is difficult to see and
may require you to place your head into the cutout
opening to locate.
19
Publicité
