Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FALÒ
The Product must always operate exclusively with the ash drawer inserted. The solid combustion residues (ash) must be collected in a
sealed, fire resistant container. The Product must never be on in the presence of gaseous emissions or vapours (for example glue for
linoleum, petrol etc.). Never deposit flammable materials near the Product.
During combustion, thermal energy is released which leads to considerable heating of the surfaces, doors, handles, controls, glass parts,
the flue gas pipe and possibly the front part of the appliance. Avoid contact with these elements unless using suitable protective
clothing or accessories (heat resistant gloves, control devices).
Ensure children are aware of these dangers and keep them away from the furnace when it is on.
When using the wrong fuel or one which is too damp, due to deposits present in the flue, a flue fire is possible.
4.1. IN A EMERGENCY
If there is a fire in the flue connection :
a)
Close the loading door and the ash drawer door
b)
Close the comburent air registers
c)
Use carbon dioxide ( CO
d)
Request the immediate intervention of the Fire Brigade
DO NOT PUT OUT THE FIRE WITH WATER.
When the flue stops burning, have it checked by a specialist to identify any cracks or permeable points.
5. TECHNICAL DESCRIPTION
Definition: product according to EN 13240.
The chimney stoves of La NORDICA are suitable to heat living spaces for some periods. As fuel, wood logs are used.
The appliance is made up of a series of cast-iron elements joined to one another by a fixed joint, while the seal is assured by refractory
putty. The assembly is supported by tie rods and nuts located outside the heating body.
The chimney stove is made of sheets of metal in galvanized steel, cast iron and thermo radiant IRONKER®. Inside it there is an extractable
grate.
The fireplace is equipped with a sight door with ceramic glass (resistant up to 700°C). This allows a charming sight on burning flames.
Moreover, in this way, any possible leak of sparks and smoke is avoided.
Room heating takes place:
a)
By irradiation: through the panoramic glass and the external hot surfaces of the stove, the heat is radiated into the environment;
b)
By natural convection: the passage of air through the coating and the covering hood releases heat in the
The device is equipped with registers of primary and secondary air.
A- PRIMARY air register
With the primary air control
direction. The primary air is necessary for the combustion process. The ash drawer must be regularly emptied, so that the ash does not
obstruct the primary air entry. Through the primary air the fire is also kept alive.
During wood combustion, the register of primary air must be opened only for a while, because otherwise the wood burns fast and the stove
may overheat. For the correct arrangement (see chapter NORMAL OPERATION).
B - SECONDARY air register
Over the door of the hearth there is the secondary air control
moved to the right), especially for wood combustion, so that un-burnt carbon does not undergo a post-combustion. See chapter NORMAL
OPERATION. Through this register it is possible to adjust the power of the stove.
Leaving it slightly open, according to the flue of the chimney, it is possible to keep the glass clean.
The adjustment of the registers necessary to reach the rated calorific yield with a depression at the stack of 10 Pa (1,0 mm of column
of water) is the following one:
Fuel
Wood
1391300 - IT - EN - DE - FR
powder ) extinguishers to put out the fire
2
(Picture 6 at page 45
- A) is adjusted the passage of air through the ash drawer and the grate in the fuel
PRIMARY air
¼
Open
(Picture 6 at page 45
- B).This regulator must be open (the lever must be
SECONDARY air
½
Open
room.
TERTIARY AIR
/
17
Publicité
Table des Matières
