Listening To The Radio - Sharp SD-CX1H Mode D'emploi

Listening to the Radio

ENGLISH
E-23

Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM STEREO, FM or AM).
3
Press the TUNING or button to tune in to the desired station.
Manual tuning:
Press the TUNING or button as many times as required to tune in to the
desired station.
Auto tuning:
When the TUNING or button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
You can tune in to the desired station by pressing the
remote control.
Notes:


When radio interference occurs, auto scan tuning may stop automatically at that
point.


Auto scan tuning will skip weak signal stations.


When an RDS (Radio Data System) station is tuned in, the frequency will be dis-
played first, and then the RDS indicator will light. Finally, the station name will ap-
pear.


Full auto tuning can be achieved for RDS stations "ASPM", see page 27.
4
To receive an FM stereo transmission, press the TUNER (BAND)
button. The "STEREO" indicator lights up.


"ST" will appear when an FM broadcast is in stereo.


If the FM reception is weak, press the TUNER (BAND) button. The "STEREO" in-
dicator goes out. The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STAND-BY button to enter the stand-by mode.
or button on the