Troubleshooting Chart; Cd-Player - Sharp SD-CX1H Mode D'emploi

Troubleshooting Chart

Many potential "problems" can be resolved by the owner without calling a service
technician.

General
Symptom


"TIME ADJUST" appears when the
clock time is checked.


When a button is pressed, the unit
does not respond.


No sound is heard.


The picture on the TV screen is dis-
torted.

CD player
Symptom


Even though a disc has been loaded,
"CD NO DISC" or "Can't READ" is
displayed.


Playback does not start.


Playback stops in the middle or is not
performed properly.


Playback sounds are skipped, or
stopped in the middle of a track.
ENGLISH
E-55
Possible cause


Did a power failure occur? Reset the clock.
(Refer to page 14.)


Set this unit to the power stand-by mode and
then turn it back on.


Is the volume level set to "0"?


Are the headphones connected?


Are the speaker wires disconnected?


When a radio or TV which uses an indoor
aerial is placed near the unit, the picture on
the TV screen may be distorted or the radio
may not function properly.


It is recommended that you use an external
aerial.
Possible cause


The disc is very dirty.


Is the unit located near excessive vibrations?


Has condensation formed inside the unit?


The disc is loaded upside down.


The disc does not satisfy the standards.


The disc is distorted or scratched.


Is the unit located near excessive vibrations?


The disc is very dirty.


Has condensation formed inside the unit?

MiniDisc
Symptom


A recording cannot be made.


Even though a disc has been loaded,
"MD NO DISC" or "Can't READ" is
displayed.


Playback sounds are skipped.

Tuner
Symptom


Radio makes unusual noise consec-
utively.


The preset channel cannot be re-
called.

Remote control
Symptom


The remote control does not oper-
ate.
Possible cause


Is the MiniDisc protected against accidental
erasure?


Did you try to make recording on a playback-
only MiniDisc?


Can you see the "DISC FULL" or "TOC
FULL" message in the display?


The disc is very dirty.


Is the unit located near excessive vibrations?


Has condensation formed inside the unit?
Possible cause


The stereo system is placed near the TV or
computer.


FM/AM loop aerial is not placed properly.
Move the AC power lead away from the aeri-
al if located near.


Did a power failure occur?


Preset the channel again.
Possible cause


Is the AC power lead of the stereo system
plugged in?


The battery polarity is not correct.


The batteries are dead.


Incorrect distance or angle.


Does the remote control sensor receive
strong light?