Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Listening to the Radio
E-18
ENGLISH
All manuals and user guides at all-guides.com
Sound Control (See page 12.)
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3
Press the TUNING (
or
) button to tune in to the desired station.
Manual tuning:
Press the TUNING (
or
) button as many times as required to tune in to the
desired station.
Auto tuning:
When the TUNING (
or
) button is pressed for more than 0.5 seconds, scanning
will start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
z When radio interference occurs, auto scan tuning may stop automatically at that
point.
z Auto scan tuning will skip weak signal stations.
z To stop the auto tuning, press the TUNING (
z When an RDS (Radio Data System) station is tuned in, the frequency will be dis-
played first, and then the RDS indicator will light. Finally, the station name will
appear.
z Full auto tuning can be achieved for RDS stations "ASPM", see page 22.
To receive an FM stereo transmission:
Press the ST-MODE button on the remote control to display the "ST" indicator.
z " " will appear when an FM broadcast is in stereo.
FM Stereo Mode Indicator
FM stereo receiving indicator
z If the FM reception is weak, press the ST-MODE button. The "ST" indicator goes
out. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
01/1/9
E2.fm
or
) button again.
Publicité
Table des Matières
