Safety Instructions For Colour Application Devices - WAGNER FINISHCONTROL 6500 TS Mode D'emploi

GB
safety regulatIons
tool who are not familiar with it or who have not
read these instructions. Power tools are dangerous
when they are used by inexperienced persons.
e) take proper care of your tools. check whether the
moving parts function trouble-free and do not jam,
whether parts are broken or damaged so that the
tool function is impaired. Have damaged parts repaired
before using the tool. Many accidents have their origin in
power tools that have been maintained badly.
f) use the power tool, accessories, insert tools, etc. in
accordance with these instructions and in a fashion
specified for this special tool type. take the working
conditions and the activity to be carried out into
consideration. The use of power tools for purposes other
than the intended ones can lead to dangerous situations.
5. Service
a) have your tool repaired only by qualified specialist
personnel and only with original spare parts. This
ensures that the tool safety is maintained.
b) If the supply cord is damaged, it must be replaced
by the manufacturer or it's service agent or a
similarly qualified person in order to avoid a safety
hazard.
Safety instructions for colour application
devices
1. risks of fire and explosion
combustible gases develop in the work area
when spraying coating substances and due to the
autonomous formation of coating substances and
solvent vapors (danger zone).
risk of fire and explosion due to ignition sources in
this danger zone.
the electrically operated spray device contains
potential ignition sources (spark formation when
switching the motor on and off, when inserting and
removing the power plug, due to potential static
electricity at the spray gun)
-> device must not be used at operating sites that fall
under the explosion protection ordinance.
-> Basic unit and mains connection must be located
outside the danger zone.
-> do not use combustible coating substances and
cleaning agents -> observe product data sheets!
18
FinishControl 6500 TS
->Always seal paint or solvent containers tightly in
the vicinity of the device.
-> no ignition sources such as open fire, lit tobacco
products, glowing wires, hot surfaces, sparks e.g. due
to angle grinders etc. must be present.
-> When cleaning the device with solvent do not spray
into a container with a small opening (bung hole).
danger due to formation of an explosive gas/air
mixture.
the container into which you are spraying must be
earthed.
2. Warning: danger of injury!
never point spray gun at yourself, other persons or
animals.
3. Wear breathing equipment when spraying.
The user should be supplied with a breathing mask. In order
to avoid occupational diseases, the working instructions
provided by the manufacturer of the materials, solvents
and cleaning agents used must be complied with during
preparation, working with and cleaning the equipment.
Protective clothing, gloves and, if necessary, protective skin
cream is required to protect the skin.
4. Warning: When working with the paint spraying
system, both indoors and outdoors, care should
be taken that no solvent vapours are driven to the
motor-operated blower or that no solvent containing
vapours form in the area around the paint spraying
system. Place the motor-operated blower on the
opposite side to the object to be sprayed. When
working outdoors take wind direction into account.
When working in closed places a sufficient ventilation
must be ensured to remove the solvent vapours. the
distance from the motor – operated blower to the
object to be sprayed must be at least 3 m.
5. Warning: the device is not splash proof. It should not
be used, neither outdoors in the rain nor be sprayed
with water nor immersed in liquid. do not use the
device in damp or wet environments.
6. Warning: risk of short circuit!
keep heating station and contacts on the underside
of the container away from liquids and dirt.
do not use any containers with damaged bases.
7. Warning: risk of electric shock!
Do not block the two slides next to the heating station.
8. The sliders must always be able to move freely. Clean
whenever necessary.