WAGNER FINISHCONTROL 6500 TS Mode D'emploi page 25

FinishControl 6500 TS
9. The units may only be used with a functional valve. If
paints rises in the ventilating hose (Fig. 1, item 18) do
not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the
diaphragm if necessary.
10. Do not lay the filled spray gun down.
11. Extraction systems should be installed on-site according
to the local regulations.
12. The object to be coated must be earthed.
13. Caution against dangers that can arise from the sprayed
substance and observe the text and information on the
containers or the specifications given by the substance
manufacturer.
14. Do not spray any liquid of unknown hazard potential.
15. Warning: risk of injury from mixer! the heating and
cleaning procedures may only be carried out when
the container is closed.
16. do not start the heating process until the mixer has
been mounted. If the mixer is not in place, the paint will
harden in the container.
17. Before dismounting the spray attachment, relieve
pressure by opening the container.
18. Before working on the device, remove the power plug
from the socket.
19. Work or repairs on the electrical equipment should only
be carried out by a professional electrician, even if there
are instructions regarding such work in the operating
instructions. No liability will be accepted for improper
installation.
20. Do not sit or stand on the device. Danger of tilting/
breaking!
GB
safety regulatIons
19