Publicité
Les langues disponibles
Les langues disponibles
Before measurement, refer to "Notes for Accurate Measurement" on the next
page.
Normal Measurement
1.
Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2.
Press the
All of the display segments are displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the
figure at the right, as the measurement
begins. The cuff starts to inflate. It is
normal for the cuff to feel very tight. A
pressure bar indicator is displayed, on the
left edge of the display, during inflation.
Note: If you wish to stop inflation at any time,
press the
3.
When inflation is complete, deflation starts
automatically and
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained, the
device starts to inflate again automatically.
To avoid re-inflation, refer to "Measurement
with the Desired Systolic Pressure" on the
next page.
4.
When the measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
5.
Press the
START
Note: Allow at least three minutes between
measurements on the same person.
Measurements
button.
START
button again.
START
(heart mark) blinks,
button to turn the device off.
segments displayed
Systolic pressure
Diastolic pressure
WHO classification
English 13
At heart level
Press
All of the display
Zero display
Starts inflation
Pressurizing
Measurement
in progress
Pulse rate
Exhausts remaining
air automatically
START
Publicité
