Sygonix 1644465 Notice D'emploi page 25

7. Connection
The surveillance camera is equipped with a connection cable with two connectors on the end.
The video signal is sent via the BNC connector, so that it can be recorded on a DVR for example. Use a suitable
adapter if you cannot use a BNC video cable.
The surveillance camera is connected to the external power supply via the round socket (direct current,
12 V/DC). A suitable round plug is needed for the connection, outer diameter 5.5 mm, inner diameter 2.1 mm.
The outer contact of the round plug should be Minus/"-", the inner contact Plus/"+".
Improper connection or connecting to the wrong voltage may damage the surveillance camera; loss
of warranty!
If you install and use the surveillance camera in outdoor areas, the two connectors must be placed
in a location that is protected from moisture. For this purpose, see chapter 6. If this is not observed,
the connectors will corrode!
Configure your DVR and the monitor connected to it so that the surveillance camera image is displayed.
Important!
The surveillance camera comes with "AHD" mode preset by default. Your DVR must therefore be
configured accordingly or support an AHD video signal. Otherwise, no image will be displayed or
only image interference.
Once you have the correct display on your monitor, you can adjust the surveillance camera precisely so that
the desired screen section can be seen and recorded to your DVR.
In the dark, the IR LEDs on the surveillance camera are activated automatically. However, the IR light is not
visible to the human eye. Please bear in mind that the image on a connected monitor will not be displayed
in colour at night but in black and white instead (can be configured in the surveillance camera's OSD menu).
25