Sygonix 1644465 Notice D'emploi page 24

6. Assembly
• First loosen the mounting ring and the retaining ring from the surveillance camera. To do this, loosen the
three small headless screws on the retaining ring so that the mounting ring and the retaining ring can be
removed from the surveillance camera.
• Mark the appropriate positions through the three mounting holes in the mounting ring if you need to drill
holes to secure the mounting ring.
A large enough hole for routing the connection cable must also be drilled if this needs to hidden and
tamper-proof.
Please make sure that you do not damage existing cables or wiring when drilling/screwing into
place.
Select the installation site so it is protected against attempts to tamper with the surveillance cam-
era. For this reason, the surveillance camera should be mounted at a minimum height of 2.5 m.
• Either run the connection cable from the side under the mounting ring or run it through a hole in the wall
where you want to screw the mounting ring.
Protect the plug against dust and dirt, e.g. with a small plastic bag.
If the connection cable is too short (depending on the wall strength and installation position), a suit-
able connection box must be used. Depending on where the surveillance camera is mounted, this
connection box must be suitable for outdoor installation. The cable connection for the video output
and the power supply can be positioned in the connection box.
Lay the cable in such a way that it is protected against tampering, e.g., in a cable duct, pipe or
similar.
• Place the surveillance camera on the mounting ring and then insert the retaining ring. Align the surveillance
camera accordingly and tighten the three small headless screws in the retaining ring so that the retaining
ring and the surveillance camera are firmly fixed to the mounting ring.
24