EKOM DK50 2V Notice D'utilisation page 32

Dental compressor DK50 2V, DK50 2V/110, DK50 2x2V/110 (Fig.7)
After removing all packaging material, place the product on the floor and remove stabilization parts X and Y
(Detail A). Connect output hose with end-piece to the appliance. Plug the mains cord plug into a socket.
Dental compressor in box DK50 2VS (Fig.6, Fig.7)
After removing all packaging material, place the product on the floor and remove stabilization parts X and Y
(Detail A). Place the wall-mounted stopper (28) - 2 pcs onto the compressor housing in the rear top part of
the housing and put the housing onto a required place. The stoppers provide a sufficient distance of the
housing from a wall for thorough ventilation. For setting up the compressor in housing you must open the
door on the housing using the attached key and remove connecting reinforcement (27) in the front bottom
part of housing. If necessary, the door may be disassembled using door hinge (32). Connect the compressor
via distributions prepared in advance in a floor according to the installation plan or via holes in the rear part
of the housing (Fig.8). Protrude pressure hose via a hole in housing and connect it to the appliance in a
suitable way. Insert the compressor using built-in wheels (33) to the housing. Fix the hose of a manometer in
a hose into the fast-on coupling on a compressor, put the connecting reinforcement (27) back and connect
the pressure hose to a compressor. Insert the electric power cord (39) of a compressor into a socket (34) on
a housing. Close the housing doors and duly lock the lock (26). Connect the mains plug into the mains
socket.
It is not allowed to leave the key in a lock! It must be saved against non-instructed persons!
Dental compressor in box DK50 2VS/M (Fig.6, Fig.7)
After removing all packaging material, place the product on the floor and remove stabilization parts X and Y
(Detail A). Place the compressor into housing similarly as in the previous paragraph. Prior to placing the
compressor into housing, protrude house for condensate drain via hole in housing and connect it to a bottle
(22). The magnetic holder (31) with a vessel (22), for entrapping condensate from a dryer may be fixed at the
sides of housing or from the front on its doors. When fixing the holder with a vessel at the housing side it is
necessary to consider a space of at least 11 cm between the housing and furniture. Distance smaller than
the specified one may cause problem with handling of the vessel.
Dental compressor in box DK50 2V/110S, DK50 2x2V/110S (Fig.7)
After removing all packaging material, place the product on the floor and remove stabilization parts X and Y
(Detail A).
Dental compressor in box DK50 2V/110S/M, DK50 2x2V/110S/M (Fig.7)
After removing all packaging material, place the product on the floor and remove stabilization parts X and Y
(Detail A).
(Fig.8)
NP-DK50 2V-2
All manuals and user guides at all-guides.com
- 30 -
DK50 2V/110
Outline of the case
1 -
Outline of the base
2 -
Front part of the case - door
3 -
Pressurised air connector
4 -
Supply voltage
5 -
230V/50(60)Hz 3Gx1.5x1000
400V/50(60)Hz 5Gx1.0x3000
all dimensions in millimeters
-
wall distance min. 100mm
-
DK50 2V
G3/8"
04/2009