Installation - Commissioning; Unpacking; Unpacking Procedure - Alliance Bio Expertise DistriWEL Manuel D'utilisation

Distriwel – Août 2017
Installation – Commissioning
Wherever possible, the DISTRIWEL should be installed by an Alliance Bio Expertise technician.
It is advised to install our equipment on a bench capable of bearing a
and, if possible, have a height of approx. 80cm to facilitate access to the


Unpacking

Unpacking procedure


Only the cross is installed in the machine at the time of delivery.
Before any initial handling or operation, check that the device is adjusted to fit the dishes used in your Laboratory.
If not, the device will have to be adjusted (preferably by an ABE technician) followed by a test run while empty.
Please follow the procedure below to assemble the device:
1. Slide the cross under the
plate
3. Position the carousel on
the plate. Make sure that it
is correctly fitted on the
indexing pin and shaft.
30 kg load. This bench should be perfectly flat
carousel.
2. Secure the cross using the
blocking handle
4. Secure the carousel using
the central blocking handle