Pairing A Second Bluetooth Device; The Boomboom 100 As A Receiver (Rx); Audio Outputs; Switching On - Marmitek BOOMBOOM 100 Guide Utilisateur

Table des Matières

Les langues disponibles

The sound from your TV will now be played over your headphones

or speaker.

4.2.4

Pairing a second Bluetooth device

The BoomBoom 100 allows you to pair two Bluetooth receivers

simultaneously. After pairing the first Bluetooth device, put the

second device in pairing mode.

Slide the multifunctional switch (2) all the way to the right (BT).

The LED will now start to blink red/blue, indicating that the

BoomBoom 100 is ready for pairing. Now slide the multifunctional

switch back to the centre position for optical connection (OPT), or

all the way to the left for analogue connection (AUX).

The pairing with the first Bluetooth device will be momentarily

interrupted, after which both Bluetooth devices will be paired with

the BoomBoom 100. This may take up to two minutes.

4.3

The BoomBoom 100 is a slim and compact Bluetooth audio

receiver that digitally streams hifi audio wirelessly from your

smartphone or tablet to your audio system.

4.3.1

The audio outputs are only used if the BoomBoom 100 is set as a

receiver. If the BoomBoom 100 is set as a receiver, it requires an

audio source to receive audio wirelessly. This source may be a

Bluetooth-enabled smartphone, tablet or computer.

4.3.2

Slide the TX/Off/RX switch to the RX position.

The blue LED will now start to blink slowly, indicating that the

BoomBoom 100 is switched on.

Table des Matières

Table des Matières