Chef'sChoice Edgecraft E120 Mode D'emploi page 4

UNDERSTANDING THE VERSATILE
MODEL E120 SHARPENER
The unique EdgeCraft® Diamond Hone® Sharpener is designed so that you may sharpen
each knife according to your intended use, such as gourmet food preparation, butchering,
dressing of game or filleting of fish. You can sharpen knives with either straight or serrated
edges. This three (3) stage sharpener has two precision conical sharpening/honing stages
with fine 100% diamond abrasives and one polishing/stropping stage using proprietary
flexible abrasive disks. These stages can be used in different sequences to give you either
an astonishingly sharp, smooth faceted edge for effortless cutting and presentations or
one with a selected amount of residual "bite" along the facets. The edge is ultra sharp
and non-serrated. This residual "bite" is created by precisely polished micro flutes that
are formed on the facet surface by the ultra honing action of the stropping disks in Stage
3. You will find that these sharp flutes on each side of the ultra sharp and non-serrated
cutting edge aid substantially in those difficult cutting chores experienced with fibrous
foods, meats, stalky vegetables, dressing of game or household chores such as cutting
cardboard, leather, carpet, etc.
The sharpening and honing/polishing actions are controlled by using precision angle
guides for the blade and precisely matched conically shaped abrasive disks. The
sharpening angles are several degrees larger in each successive stage.
Fine diamond-coated conical disks in Stage 1 create microgrooves along the facets on
®
each side of the edge, establishing the first angled bevel of the Trizor edge.
In Stage 2, finer microgrooves are created across the facets immediately adjacent to the
edge by still finer diamonds as they establish a well defined second bevel on the facets
that is a few degrees larger than the bevel developed in Stage 1.
In Stage 3, ultra fine abrasive disks are set at a third and slightly larger angle. They polish
and strop the facets immediately adjacent to the edge creating a third micro bevel and
establish a microscopically thin, straight and super polished edge of astonishing
sharpness. The stropping action simultaneously polishes and sharpens the boundaries of
those microgrooves created by the diamond abrasives in Stages 1 and 2 adjacent to the
edge until they become sharp micro flutes that will assist the cutting action of "difficult to
cut" materials.
This unique three stage design gives you an edge of remarkable sharpness and,
because of the triple angle bevel it creates on each facet, you will note knives stay sharp
much longer.
The following sections describe the general procedures for optimal sharpening in each
stage and then suggest how you can optimize the edge for your intended uses.
Unless you do a lot of heavy duty cutting, you will need to use Stage 1 only infrequently.
One of the important advantages of using the EdgeSelect Model E120 is that you can
strop and polish your knives to razor sharp edges as often as needed and yet experience
little knife wear compared to older sharpening methods. Resharpening can usually be
done in Stage 3. Use Stage 2 less often for resharpening and use Stage 1 only for the
heaviest duty applications. (See Resharpening Section).
English — 4