Setting Up A Master Slave Chain; Mains Connection - MC Crypt 59 12 82 Notice D'emploi

DMX Connection

Setting up a master slave chain

The effect light can be operated controlled by a DMX controller or in a master slave chain. In that case, the integrated
controller of the master device controls the connected slave devices.
• Connect the DMX OUT connection on the master device to DMX IN connection on the first slave device.
• Connect the DMX OUT connection of the first slave device to the DMX IN connection of the second slave device.
• Proceed accordingly with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT connection of the last slave device (as described
in section "Connection of a DMX controller").

Mains Connection

The mains socket to which the effect light is connected must be easily accessible to quickly
separate the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause
potentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Never overload the mains output IEC POWER OUT. The maximum load capacity of the mains
output is 10A. The maximum consumption of all connected devices must not exceed this value.
• Connect the mains connector of the mains cable into the mains connection IEC POWER IN at the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, it takes up operation.
• Through the mains output IEC POWER OUT, other effect beamers can also be connected to the mains. For this,
plug in a mains extension (available in specialist stores) in the mains output IEC POWER OUT and connect it
to the mains connection of another device.
24