Handling
•
Never connect the mains plug to a mains socket immediately after the device was taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
•
Never plug in or unplug the mains plug when your hands are wet.
•
Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the intended
grip areas.
•
Unplug the mains plug from the mains socket if you do not use the device for an extended period of time.
•
Disconnect the mains plug from the mains socket in thunderstorms for reasons of safety.
•
Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any objects
like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.5m around the device.
Maintenance
Regularly check the technical safety of the effect beamer, e.g. for damage to the mains cable or the casing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make
sure it is not unintentionally operated. Pull the mains plug from the mains socket!
It can be assumed that safe operation is no longer possible if:
•
the device is visibly damaged
•
the device no longer works
•
the device was stored under unfavourable conditions for an extended period of time or
•
after exposure to extraordinary stress caused by transport
Always observe the following safety instructions before cleaning or servicing the effect beamer:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work
is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must
perform repairs.
27