Publicité
Les langues disponibles
Les langues disponibles
MOUNTING:
Only technicians who are familiar with the technical terms, warnings, and
instructions in the manual and who are able to follow these should connect the
module.
Should there be any doubt as to the correct handling of the module, please con-
tact your local distributor or, alternatively,
PR electronics A/S, Lerbakken 10, DK-8410 Rønde, Denmark,
tel: +45 86 37 26 77.
Mounting and connection of the module should comply with national legislation
for mounting of electric materials, i.a. wire cross section, protective fuse, and
location. Descriptions of input / output and supply connections are shown in the
block diagram and side label.
The following apply to fixed hazardous voltages-connected modules:
The max. size of the protective fuse is 10 A and, together with a power switch, it
should be easily accessible and close to the module.
The power switch should be marked with a label telling it will switch off the volt-
age to the module.
Year of manufacture can be taken from the first two digits in the serial number.
CALIBRATION AND ADJUSTMENT:
During calibration and adjustment, the measuring and connection of external
voltages must be carried out according to the specifications of this manual.
The technician must use tools and instruments that are safe to use.
NORMAL OPERATION:
Operators are only allowed to adjust and operate modules that are safely fixed in
panels, etc., thus avoiding the danger of personal injury and damage. This means
there is no electrical shock hazard, and the module is easily accessible.
CLEANING:
When disconnected, the module may be cleaned with a cloth moistened with
distilled water or ethyl alcohol.
LIABILITY:
To the extent the instructions in this manual are not strictly observed, the custom-
er cannot advance a demand against PR electronics A/S that would otherwise
exist according to the concluded sales agreement.
32
All manuals and user guides at all-guides.com
As manufacturer
hereby declares that the following product:
is in conformity with the following directives and standards:
EMC directive 2004/108/EC and later amendments
This declaration is issued in compliance with article 10, subclause 1 of the EMC
directive. For specification of the acceptable EMC performance level, refer to
the electrical specifications for the module.
The Low Voltage directive 73/23/EEC and later amendments
The ATEX directive 94/9/EC and later amendments
Notified body for CENELEC/ATEX: UL International Demko A/S 0539
Rønde, 6 Feb. 2006
DECLARATION OF CONFORMITY
PR electronics A/S
Lerbakken 10
DK-8410 Rønde
Type: 5111
Name: Universal transmitter
EN 61326
EN 61010-1
EN 50014, EN 50020 and EN 50281-1-1
ATEX certificate: DEMKO 01ATEX130321
Peter Rasmussen
Manufacturer's signature
33
Publicité
