Connector Panel - Sony VPL-S500U Mode D'emploi

0 MUTING keys
Cuts off the picture and sound.
PICTURE: Press to cut off the picture. Press again
to restore the picture.
AUDIO: Press to cut off the sound. Press again or
press the VOLUME + key to restore the sound.

Connector panel

1 VIDEO IN connectors
S VIDEO (mini DIN 4-pin): Connects to the S video
output (Y/C video output) of a video equipment.
VIDEO (BNC-type): Connects to the composite
video output of video equipment.
Note
If you have video equipments connected to both the S
VIDEO and VIDEO connectors, the signal from the S
VIDEO is selected. When showing video connected to
the VIDEO connector, be sure not to connect a cable to
the S VIDEO connector.
2 AUDIO IN L (MONO)/R jacks (phono type)
Connect to the audio output jacks of an equipment. For
stereo equipment, use both the L and R jacks; for
monaural equipment, use the L (MONO) jack only.
3 INPUT A connectors
RGB input connector (HD D-sub 15-pin, female):
Connect to the monitor output connector on a
computer using the supplied cable. Use the
optional cable to input a component signal.
75-ohm termination switch (ON/OFF): Normally
set to ON. Set it to OFF when the projector is
connected to a computer and a monitor.
AUDIO IN jacks (stereo minijack): Connects to the
audio output jack on a computer.
!¡ PATTERN key
Display a pattern on the screen for focus adjustment.
Press again to clear the pattern.
S VIDEO VIDEO
L (MONO) R
VIDEO IN AUDIO IN
1 2
4 AUDIO OUT L/R jacks (phono type)
Connects to external active speakers.
The volume of the speakers can be controlled by the
VOLUME keys on the projector or the Remote
Commander.
5 CONTROL S IN/PLUG IN POWER (DC 5V)
jack (stereo minijack)
Connects to the CONTROL S OUT jack of the
supplied Remote Commander when using as a wired
Remote Commander.
INPUT A
L R
75Ω
ON
OFF
AUDIO IN AUDIO OUT CONTROL S IN
3 4 5
9
(EN)