Color Temp - Sony VPL-S500U Mode D'emploi

The INPUT SETTING Menu
SHIFT
Adjusts the position of the picture input from INPUT
A.
S H I F T H : 1 9 1 V : 2 0
H adjusts the horizontal position of the picture.
V adjusts the vertical position of the picture.
As the setting for H increases, the picture moves to the
right, and as the setting decreases, the picture moves to
the left.
As the setting for V increases, the picture moves up,
and as the setting decreases, the picture moves down.
Use the B or the b key to adjust the horizontal position
and the V and v key for the vertical position.
FILTER
Corrects the vertical bands that appear on the picture
input from INPUT A.
I N P U T - A
D O T P H A S E : 1 0
INPUT
SELECT S I Z E H : 1 0 5 6
S H I F T H : 1 9 1 V : 2 0
PICTURE
F I L T E R : O N
CTRL
C L A M P : A O F F
INPUT
SETTING C O L O R T E M P : H B M
SET
S A V E T O M E M O R Y
SETTING
RESET: RESET
INPUT
INFO.
SEL: SET: ENTER EXIT: MENU
The vertical bands may occur when an RGB signal
which horizontal resolution is other than 640 dots is
input. In such cases, set to ON. The picture will loose
some clarity, but the vertical bands will be reduced.
Set to OFF to associate a dot of the input signal with a
pixel of the LCD.
24
(EN)
CLAMP
Corrects the luminance of the picture input from
INPUT A.
I N P U T - A
D O T P H A S E : 1 0
INPUT
SELECT S I Z E H : 1 0 5 6
S H I F T H : 1 9 1 V : 2 0
PICTURE
F I L T E R : O F F
CTRL
C L A M P : A U T O
INPUT
C O L O R S o n G H B M
SETTING
H / C
SET
SETTING S A V E T O M E M O R Y
RESET: RESET
INPUT
INFO.
SEL: SET: ENTER
EXIT: MENU
CLAMP is used as a standard for setting the black
level of a picture correctly. The standard position of
the clamp depends on the kind of sync. signal being
used. Normally, the projector CPU judges the signal
and sets the position automatically. However, the CPU
can misjudge the signal because of noise. If the
luminance of the picture seems to be incorrect (too
dark, the black color is too light, or the luminance is
unstable) the clamp position may need to be changed.
AUTO: Automatic setting mode. Normally set to this
position.
SonG: Set to this position if the black seems too light
or greenish.
H/C: Set to this position if the picture is too dark or
luminance is unstable.
Note
If the luminance is still incorrect after changing the
clamp setting, check the input signal and the
connections.

COLOR TEMP

Adjusts the color temperature.
I N P U T - A
D O T P H A S E : 1 0
INPUT
S I Z E H : 1 0 5 6
SELECT
S H I F T H : 1 9 1 V : 2 0
PICTURE
CTRL F I L T E R : O F F
C L A M P : A U T O
INPUT
SETTING C O L O R T E M P : H I G H
L O W
SET
S A V E T O M E M H B M
SETTING
RESET: RESET
INPUT
INFO.
SEL: SET: ENTER EXIT: MENU
HIGH: Makes the white color bluish.
LOW: Makes the white color reddish.
HBM (High Brightness Mode): Reproduces a
picture with high brightness.