Sony VPL-S500U Mode D'emploi page 8

Location and Function of Controls
Control panel
PATTERN
!¡
1 POWER key
Press to turn the projector on and off once the
projector is in the standby mode. The POWER
indicator lights in green when the power is turned on.
When turning off the power, press the POWER key
twice following the message on the screen, or press
and hold the key for about one second.
For details on steps for turning off the power, see "To turn off
the power" on page 17 (EN).
2 LIGHT key
Lights the back lighting (orange) for the control panel
when the power is turned on. Press again to turn off
the back lighting.
3 Indicators
POWER: Lights in green when the power is turned
on.
Flashes in green while the cooling fan runs after
turning off the power with the POWER key. The
fan runs for about 90 seconds after turning off the
power.
The POWER indicator flashes quickly for the first
minute. During this time, you will not be able to
turn the power back on with the POWER key.
STANDBY: Lights in red when the MAIN POWER
switch at the rear of the projector is turned on.
Once in the standby mode, you can turn the
projector on with the POWER key on the control
panel or the Remote Commander.
Note
When the MAIN POWER switch is turned off,
there will be a slight delay before the indicator goes
off.
LAMP: Lights up or flashes under the following
conditions:
• Lights up when a trouble has prevented the lamp
from lighting.
• Flashes when the lamp cover or air filter cover is
not secured firmly.
8
(EN)
PICTURE
MUTING VOLUME
AUDIO RESET
!º 9 8 7
POWER
INPUT
MENU POWER
SELECT
u
STANDBY
LAMP
ENTER LIGHT
TEMP
6 5 4 3
Note
When the LAMP indicator lights up, never open the
lamp cover if the projector is installed on the
ceiling.
TEMP (Temperature): Lights up or flashes under
the following conditions:
• Lights up when temperature inside the projector
becomes unusually high.
• Flashes when the fan inside the projector stops.
For details on the LAMP and the TEMP indicators, see page
35 (EN) .
4 INPUT SELECT key
Selects the input signal. Each time the key is pressed,
the video signal is switched between the VIDEO IN
and INPUT A connectors and the audio signal is
switched between the AUDIO IN L/R jacks and
INPUT A connectors.
5 MENU key
Press to display the on-screen menu. Press again to
clear the menu.
6 ENTER key
Press to enter the settings of items in the menu system.
7 Arrow keys (V/v/B/b)
Used to move the on-screen cursor or to make various
adjustments.
8 RESET key
Press to restore the value of an item back to its factory
preset value. This key functions when the menu or a
setting item is displayed on the screen.
9 VOLUME +/– keys
Adjust the volume of the built-in speakers and output
level of the AUDIO OUT jacks.
+ : Increases the volume.
– : Decreases the volume.
1
2