Sony VPL-S500U Mode D'emploi page 18

Projecting
To turn off the power
18
(EN)
1
Press the POWER key on the control panel or the Remote
Commander.
The following message appears to verify if you really want to turn off
the power.
P O W E R O F F ?
P l e a s e p r e s s
k e y a g a i n .
POWER
Note
The message will disappear if you press a key except the POWER key,
or if you do not press any key for five seconds.
2
Press the POWER key again on the control panel or the Remote
Commander.
The POWER indicator flashes in green and the fan continues to run for
about 90 seconds to reduce the internal heat. The POWER indicator
flashes quickly for the first minute. During this time, you will not be
able to turn the power back on with the POWER key. After about one
minute, you can turn on the power with the POWER key.
3
Wait until the fan stops running and the STANDBY indicator lights in
red; then press the MAIN POWER switch to turn off the main power
(o OFF).
When you cannot confirm the on-screen message
When you cannot confirm the on-screen message in a certain condition,
you can turn off the power by holding the POWER key on the control
panel or the Remote Commander for about one second.
Notes
• Do not press the MAIN POWER switch while the fan is still
running; the fan will stop while the lamp is still hot, leading to
breakdown.
• To make the lamp life last longer, do not turn off the power at
least for about 10 minutes after turning on the power.