Dolmar MG5300.4 Instructions D'emploi page 17

► 1. Throttle valve 2. Idling adjusting screw 3. Control
cable 4. Throttle valve stopper
If the throttle valve does not touch the throttle valve
stopper even you pull the throttle trigger fully or if the
throttle valve does not touch the idling adjusting screw
while idling, turn the cable adjusting bolt as follows:
1. Loosen the fixing nut.
2. If the throttle valve does not touch the throt-
tle valve stopper, turn the cable adjusting bolt
counterclockwise.
If the throttle valve does not touch the idling adjusting
screw, turn the cable adjusting bolt clockwise.
1
► 1. Cable adjusting bolt 2. Fixing nut
3.
Tighten the fixing nut to fasten the cable adjusting
bolt.
4. Check the movement of the throttle valve. The
throttle valve comes to the position as illustrated when
the throttle trigger/lever is pulled/turned.
1
4 3 2
2
17 ENGLISH
Cleaning carburetor cover
If the carburetor cover gets dirty and it is difficult to check the
throttle valve, clean the carburetor cover as follows:
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like for cleaning the carburetor
cover. Otherwise it may be tarnished.
1. Pass a slotted screwdriver through the hole on the
engine cover. Release the clamp of the carburetor cover.
1
► 1. Carburetor cover
2. Clean the carburetor cover.
NOTICE:
Use wet clean cloth for cleaning the
carburetor cover.
3. Return the carburetor cover. Make sure the clamp
of the carburetor cover clicks when it is set in place.
Inspecting bolts, nuts and screws
and other parts
Retighten loose bolts, nuts, etc.
Check for fuel and oil leakage.
Replace damaged parts with new ones for safety operation.