Eureka ATOM TOUCH Manuel D'instructions page 31

EN
3 DESCRIPTION OF THE APPLIANCE
1. Container lid
2. Container for coffee beans
3. Coffee bean container
opening/closing tab
4. Grinding adjustment knob
5. Touch screen display
A. Selected dose time viewer
B. Time decrease button
C. Dose 1 selection
D. Extra dose selection
E. Active alarm
F. Time increase button
G. Dose 2 selection
H. Continuous dose selection
4 ADJUSTMENTS AND USE
4.1 PRELIMINARY OPERATIONS
Before starting work, the machine must be set up according to the type of coffee blend
(roasting level) and grinding.
• Insert the adapter (10) in its seat (Fig.2) positioning it with the hole aligned with the
rear screw and lock it in place by tightening the screw (Fig.3)
• Insert the container for coffee beans (2) into its seat (Fig.4) positioning it with the
hole aligned with the screw located behind it (Fig.5) and lock it in place by tightening
the screw.
• Push the tab (3) to prevent the coffee beans from passing through (Fig.6).
• Remove the lid (1) from the container (2) and fill it with coffee beans.
• Put the lid (1) back on and pull the tab (3) to allow the coffee beans to pass through.
4.2 GRINDING ADJUSTMENT
To adjust the grinding degree, use the adjustment knob (4), turning it clockwise to make
the powder finer or counter-clockwise to increase the grain size as indicated on the
knob (Fig.7). The adjustment is without stops; it must be carried out gradually, grinding
a little coffee every 2 notches at the most.
ATTENTION
If the knob is turned by one full turn with the motor stopped, the machine may
stop.
6. Dispensing nozzle
7. Grinding start up button
8. Filter holder fork
9. Ignition button
10. Adapter
I. Locked dose adjustment
J. Access to the menu
K. Next page
L. Previous page
M. Access to technical menu
N. Menu exit
O. Back
31