Eureka ATOM TOUCH Manuel D'instructions page 36

5.3.7 LANGUAGE
This screen allows selecting the language. The language
currently in use is shown on the screen as a preview. Press
the SET key to change the language, choosing from one of the
languages listed.
5.3.8 STANDBY
This screen is used to activate and deactivate standby and to
set the minutes to wait before it activates. When standby is
active the main screen disappears and the logo appears. To
reactivate the main screen, press anywhere on the screen.
ON: Standby enabled
OFF: Standby disabled.
Use the "+" and "-" buttons to increase or decrease the minutes
of inactivity before going into standby.
5.3.9 RESET DATA SETTINGS
This screen allows restoring the appliance factory settings set by
the Manufacturer.
Long press the RESET key to restore the factory settings.
6
CLEANING AND MAINTENANCE
ATTENTION
Disconnect the appliance from the power supply before carrying out any
cleaning and maintenance operations.
Do not pull the power cord or the appliance itself to disconnect the plug from
the power supply socket.
ATTENTION
Maintenance operations must be performed by specialised technicians
authorised by the manufacturer.
36
EN
LANGUAGE
ENGLISH
SETTING
STANDBY
05
FACTORY DATA
RESET
RESET